Positioning the Turf-Compensation Spring (continued)
G402721
4. Assemble the bolt of the turf-compensation
spring to the right tab
of the carrier frame
with the flange locknut (3/8 inch)
.
G402722
5. Align the holes in the turf-compensator bracket
with the holes in the cutting-unit frame.
Note: The support loop of the hose guide
aligns toward the center of the machine
.
6. Assemble the turf-compensator bracket
to
the cutting-unit frame with the 2 carriage bolts
(3/8 x 1-1/4 inches)
and 2 flange locknuts
(3/8 inch)
.
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
8. Repeat this procedure for the other cutting unit.
Installing the Front Cutting Units to the Lift Arms
G402695
1. Install the front cutting units to the lift arms as
shown.
2. Lock the cutting-unit pivot for cutting grass on
a hill side.
Setup: Installing the Cutting Units Page 3–5 3464-478 A
To Next Page
Loading...
