Toro Reelmaster 5100-D - Page 174

________________________________________________________________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
__
__ __ __ __ __ __
__ __ __ __ __ __
__ __ __ __ __ __
__ __ __ __ __ __
Condition Possible Cause Correction
Rear (No. 2 and 3) cutting units Problem with solenoid S5. Test solenoid S5 and
replace if
will not raise/lower
, but other faulty.
cutting units raise and lower O
K.
Check wiring to solenoid S5 and
repair if necessary.
Hydraulic problem. See Troubleshooting section of
Chapter 4 - Hydraulic System.
Front cutting units do not Problem with solenoid S8. Test solenoid S8 and
replace if
backlap, but run forward instead. faulty.
Check wiring to solenoid S8 and
repair if necessary.
Hydraulic problem. See Troubleshooting section of
Chapter 4 - Hydraulic System.
Front cutting units do not Front backlap switch circuit open. Test
front backlap switch and
backlap, but ALL cutting units run replace if faulty.
forward instead.
Check wiring to front backlap
switch and repair if necessary.
Rear cutting units do not backl
ap, Problem with solenoid S9. Test solenoid S9 and replace if
but run forward instead. faulty.
Check wiring to solenoid S9 and
repair if necessary.
Hydraulic problem. See Troubleshooting section of
Chapter 4 - Hydraulic System.
Rear cutting units do not backlap, Rear backlap switch circuit open. Test
rear backlap switch and
but ALL cutting units run forward replace if faulty.
instead.
Check wiring to rear backlap
switch and repair if necessary.
Troubleshooting Page 5 -
16 Reelmaster
®
5100-D