Toro Reelmaster 5100-D - Page 212

7. After drilling, put a chisel in position across the hole
and strike sharply to break the ring. Replace with a new
ring at time of reassembly (Fig. 11).
Wear protective safety goggles when break-
ing the retaining ring. Personal injury could
result from flying metal particles. Keep all
personnel away during this procedure.
WARNING
8. Inspect the shaft for possible damage (Fig. 12).
Inspect the sealing surface of the hub and shaft.
Replace it if the seal has grooved the surface more that
1/64 inch (0.4 mm).
9. Put a new grease seal, brake assembly, and a new
gr
ease packed bearing (in that order) onto the axle
shaft.
Figure 11
Figure 12
10. Press the assembly until the bearing is firmly seated
against the axle shaft shoulder (Fig. 13).
Figure 13
Repairs Page 6 - 6 Reelmaster
®
5100-D