7. Support the drive pinion in a suitable press (Fig. 41).
Figure 41
8. Install the outer pinion spacer with the chamfer
towards the pinion splines and install the new outer
pinion bearing cone (Fig. 42).
Figure 42
9. With a hollow press sleeve of proper diameter, press
on the outer bearing cone race until the drive pinion
seats in the carrier and a slight drag is noticed when the
gear is rotated by hand (2-13 in.-lb. torque to rotate)
(Fig. 43). If the drag is to severe, tap the pinion shaft
with a soft mallet until the drag is reduced.
Figure 43
Reelmaster
®
5100-D Page 6 - 17 Repairs
To Next Page
Loading...
