Toro Reelmaster 5100-D - Page 270

14. Align the five holes and press the five alignment pins
in place (Fig. 76).
IMPORTANT: Make sure the five alignment pins are
pressed below the surface of the commutator.
Figure 76
15. Put a few drops of oil into each recess in the
commutator (Fig. 77).
Figure 77
16. Put the commutator ring (either side up) on top of
the stator (Fig. 78). Align the commutator ring screw
recesses with the stator screw slots.
Figure 78
Repairs Page 7 - 40 Reelmaster
®
223-D/5100-D/5300-D