Reelmaster 5010 SeriesHydraulic System (Rev. C) Page 4 -- 80
Wheel Motor Service (Parker)
1. Cap screw (7 used)
2. End cover
3. Body seal (5 used)
4. Commutator ring
5. Commutator
6. Commutator ring
7. Manifold
8. Stator
9. Vane (7 used)
10. Rotor
11. Wear plate
12. Drive link
13. Thrust bearing
14. Coupling shaft
15. Woodruff key
16. Thrust bearing
17. Thrust washer
18. Inner bearing
19. Shaft seal
20. Back--up washer
21. Back--up ring
22. Housing
23. Outer bearing
24. Dirt and water seal
25. Lock nut
Figure 68
(61to75N--m)
45 to 55 ft--lb
4
3
1
2
9
10
11
8
5
6
7
12
3
3
3
3
13
14
15
16
17
18
19
20
21
22
23
24
25
NOTE: The front wheel motors on Reelmaster 5010
machines with serial number below 311000600 are
Parker Torqmotor
TM
TG Series. Wheel motors have an
identification tag on them which identifies the brand.
Right and left motors are the same basic design but the
rightsidemotorshaveareversetimedmanifoldtoallow
correct rotation direction for forward and reverse. The
leftsidewheel motors are identified with ayellow doton
the motor flange.
NOTE: On machines equipped with optional Cross-
Trax
TM
AWD kit, the rear wheel motors are Parker Torq-
motor
TM
TL Series.
NOTE: For Parker wheel motor repair procedures, see
theParkerTorqmotor
TM
ServiceProcedure(TC,TB,TE,
TJ,TF,TG,THand TLSeries)at theendofthischapter.
To Next Page
Loading...
