Toro Reelmaster 5210 - Special Tools

Reelmaster 5010 Series
Cutting Units (Rev. C)
Page 7 -- 4
Special Tools
Order Special Tools from your Toro Distributor. Some
tools may have been supplied with your machine or are
available as TORO parts.
Gauge Bar Assembly
Toro Part Number: 108--6715
Use gauge bar to verify height--of--cut adjustment. Also
used for adjustment of optional groomer.
Figure 2
Used for Height--of--
Cut adjustment
Used for Groomer
adjustment
Bedknife Screw Tool
Toro Part Number: TOR510880
Thisscrewdriver--type bitismadetofitTorobedknifeat-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar.
IMPORTANT: To prevent damage to the bedbar, DO
NOT use an air or manual impact wrench with this
tool.
Figure 3
Handle Assembly
Toro Part Number: 29--9100
For applying lapping compound to cutting units while
keeping hands a safe distance from the rotating reel.
Figure 4