Reelmaster 5010 Series
Cutting Units (Rev. C)
Page 7 -- 10
Factor Possible Problem/Correction
Roller condition and roller type Make sure rollers rotate freely. Repair roller bearings
as necessary.
See Roller Service in the Service and Repairs section
of this chapter.
Refer to Cutting Unit Operator’s Manual for roller
options.
Turf compensation spring adjustment Refer to Traction Unit Operator’s Manual for
adjustment procedure.
Rear lift arm counterbalance spring adjustment Refer to Traction Unit Operator’s Manual for
adjustment procedure.
Cutting unit accessories A variety of cutting unit accessories are available that
can be used to enhance aftercut appearance. Refer to
Operator’s Manual for a listing of available
accessories.
To Next Page
Loading...
