Toro Reelmaster 5410 - Page 613

AssemblingtheGroomerReel(continued)
3.Whenallthebladeshavebeeninstalled,placethenalspacerontheshaft
andthenthreadthesecondlocknutontotheshaft.Centerthebladeson
theshaftwiththelocknuts.
4.Useawrenchontheshaftatstopreventtheshaftfromturning,torquethe
secondlocknutto23to28N∙m(16to21ft-lb).Afteryoutorquethelocknut,
thespacersshouldnotbefreetorotateandthegroomerbladesshouldbe
centeredontheshaft.
5.Ifthegroomerreelisequippedwiththebroomerkit:
A.Loosenthegroomerbladeretainingnutsoneachendofthegroomer
shaft.
g236521
Figure386
1.Groomerreel
3.Blade
2.Broomerstrap(4each)
4.Brush
B.Slideabrushintoeachgroovearoundthefulllengthofthegroomerreel.
Ensurethatthebrushesareseatedingroomerbladeslots(Figure386).
IMPORTANT
Thestrapsmustbewrappedaroundthegroomerbladeandbrush
assemblyinthecorrectdirection.
C.Looselywrapthestrapsaroundthegroomerreelshaftandbrushesas
showninFigure386.Thestrapsshouldbepositionedinthepre-cut
notchesofeachbrushbetweentheblades1-2,14-15,28-29,and41-42.
Positionthebroomerbrushesproperlyinthebladeslots,andtightenthe
groomerblade—retainingnutsto23to28N∙m(16to21ft-lb).
D.Whileholdingstrapbuckleinplace,pullthestrapstightintothepre-cut
notchesofeachbrush.
E.Cutoffthestrapextensionapproximately6mm(0.25inch)beyondthe
retainerandfoldtheexcessstrapoverthebuckle(Figure386).
6.Placetheexcludersealsonthegroomershaft.
7.InstalltheO-ringontothenon-driveendofthegroomershaft.
8.Installthegroomerreelbackontothecuttingunit;refertotheGroomerReel
(page10–15).
9.Checkthegroomerreelheightandmowerheight-of-cutsettings.Adjust
asnecessary.
Reelmaster
®
5410/5510/5610Series
Page10–19
BeltDrivenGroomer(Optional):ServiceandRepairs
15216SLRevC