Toro Reelmaster 5410 - Page 14

Figure4
1.Counterweight
5.Allthecuttingunitsareshippedwiththeturf
compensationspringmountedtotherightsideof
thecuttingunit.Theturfcompensationspring
mustbemountedtothesamesideofthecutting
unitasthereeldrivemotor.Repositiontheturf
compensationasfollows:
A.Removethe2carriageboltsandnutssecuring
therodbrackettothecuttingunittabs(Figure5).
Figure5
1.Turfcompensationspring3.Springtube
2.Rodbracket
B.Removetheangenutsecuringthespringtube
capscrewtothecarrierframetab(Figure5)
Removetheassembly.
C.Mountthespringtubecapscrewtotheopposite
tabonthecarrierframeandsecurewiththe
angenut.Thecapscrewheadistobepositioned
totheoutersideofthetabasshowninFigure6.
Figure6
1.Oppositecarrierframetab
2.Rodbracket
D.Mounttherodbrackettothecuttingunittabs
withthecarriageboltsandnuts(Figure6).Also,
onthe#4cuttingunit,mountthelefthandhose
guidetothefrontofthecuttingunittabswhen
reinstallingtherodbracket(Figure7).
Note:Onthe#5cuttingunit,usetherod
bracketmountingnutstoinstalltherighthand
hoseguidetothefrontofthecuttingunittabs.
Figure7
1.Hoseguide(Lefthand
shown)
3.Carriagebolts
2.Rodbracket4.Nuts
Note:Wheninstallingorremovingthecutting
units,makesurethehairpincotterisinstalled
inthespringrodholenexttotherodbracket.
Otherwise,thehairpincottermustbeinstalledin
theholeintheendoftherod.
6.Loweralltheliftarmscompletely.
7.Removethesnapperpinandthecapfromthelift
armpivotyoke(Figure8).
14