Toro Reelmaster 5500-D - Page 253

Groomer
Reelmaster 5500−D Groomer (Rev. C)Page 8.1 − 13
Disassembly (Fig. 15)
1. Remove groomer height of cut assembly from cut-
ting unit (see Groomer Reel Removal in this section).
2. Disassemble groomer height of cut assembly using
Figure 15 as a guide.
Assembly (Fig. 15)
1. If bearing housing were disassembled, install bear-
ings and grease seals noting proper orientation of com-
ponents as shown in Figure 16.
2. Assemble groomer height of cut assembly using Fig-
ure 15 as a guide.
3. Install groomer height of cut assembly onto cutting
unit (see Groomer Reel Installation in this section).
4. Check groomer reel height and mower height−of−cut
settings. Adjust as needed.
1. Drive side housing
2. Non−drive side housing
3. Grease seal
4. Grease seal
5. Bearing
6. Plug
7. Retaining ring
Figure 16
2
1
3
4
4
5
3
6
5
7