the mark on the dipstick.
4. If the level is low, add fluid to raise the level to
the full mark.
5. Install the dipstick and cap onto the filler neck.
Check Rear Axle Lubricant
(Model 03551 only)
The rear axle has three separate reservoirs which
use SAE 80W-90 weight gear lube. Although the
axle is shipped with lubricant from the factory,
check the level before operating the machine.
1. Position the machine on a level surface.
2. Remove the check plugs (3) from the axle and
make sure lubricant is up to the bottom of each
hole.
3. If the level is low, remove the center fill plug
and add enough lubricant to bring the level up
to the bottom of the plug hole.
4. Remove each end check plug and add enough
lubricant to bring the level up to the bottom of
each plug hole.
5. Install all plugs.
Figure 6
1. Check plug
2. Fill plug
Figure 7
1. Left check plug (Rear of axle)
Check Reel-To-Bedknife
Contact
Each day before operating, check the reel-to-
bedknife contact, regardless of whether the quality
of cut has been acceptable. There must be light
contact across the full length of the reel and
bedknife.
Check Wheel Nut Torque
Before Operating
–14 –
WARNING
Tighten the wheel nuts to 61-75 Nm after 1–4
hours of operation and again after 10 hours of
operation and every 250 hours thereafter. Failure
to maintain correct torque could result in failure or
loss of a wheel, which may result in personal
injury.
1
1
2
1
To Next Page
Loading...
