Toro Reelmaster 5510 - Page 187

TestProcedure(continued)
Note:Thistestprocedureincludesstepstotestefciencyofbothfrontwheel
motorstogetherbeforetestingindividualwheelmotors.
1.Ensurethatthetractionpedalisadjustedtotheneutralposition;referto
theTractionUnitOperator’sManual.
2.Drivemachinetoanopenarea.Parkmachineonalevelsurfacewiththe
cuttingunitsloweredanddisengaged.Ensurethattheengineisshutoff.
3.ReadallWarning,Cautions,andprecautionslistedatthebeginningofthis
section.
CAUTION
Beforeopeninghydraulicsystem,operateallhydrauliccontrolsto
relievesystempressureandavoidinjuryfrompressurizedhydraulic
uid;refertoReleasingPressurefromtheHydraulicSystem(page
6–8).
4.Attachaheavychaintotherearofthemachineframeandanimmovable
objecttopreventthemachinefrommovingduringtesting.
5.Chockfrontwheelstopreventwheelrotation.
Note:IfmachineisequippedwithCrossTraxAWD,jackupandsupportthe
rearwheelsoffthegroundtoallowowthroughtherearwheelmotors.
g230039
Figure90
2-wheeldrivemachine
1.Tractionpump
3.Hydraulichose(forward)5.Hydraulichose(reverse)
2.Rightelbowtting4.Leftelbowtting
6.Cleanjunctionofhydraulichoseandrightsideelbowttingonbottomof
pistonpump(Figure90).Disconnecthosefrompistonpumptting.
IMPORTANT
Ensurethattheuidowindicatorarrowontheowmeteris
showingthattheuidwillowfromthepump,throughthetester,
andintothehydraulichose.
Reelmaster
®
5410/5510/5610Series
Page6–69
HydraulicSystem:TestingtheHydraulicSystem
15216SLRevC