Toro Reelmaster 6500–D - Page 185

Reelmaster 6500–D/6700–D
Page 4 – 97
Hydraulic System
44. Install the lock nuts onto the bolts. Tighten each nut
gradually until resistance is felt (Fig. 126). Tighten to a
torque of 20 – 24 ft–lb (27 – 33 Nm) in the sequence
shown (Fig. 127).
45. Tighten the plug to a torque of 8 – 12 ft–lb (11 – 16
Nm) (Fig. 128).
Figure 126
Figure 127
Figure 128
Hydraulic
System