Reelmaster 6500–D/6700–D
Page 4 – 98
Hydraulic System
46. Apply a small amount of clean multi–purpose
grease on the lip of the seal. Install the seal onto the
jacket tube and input shaft (Fig. 129).
47. Make a final inspection of the relative groove posi-
tions on the side of the unit (Fig. 42). Components of the
steering valve with alignment grooves, must be as-
sembled so that their alignment grooves are positioned
as illustrated for the valve to function correctly (Fig. 42).
Disassemble and correct the assembly if necessary.
48. Remove the four nuts holding the unit to the fixture
and remove the unit (Fig. 130).
Figure 129
Figure 130
To Next Page
Loading...
