Rev. B
Reelmaster 6500–D/6700–D
Page 4 – 104
Hydraulic System
10. Clamp the housing in a vise (Fig. 138). Use just
enough clamping force to hold the housing securely.
11. Lubricate and install a new o–ring seal in the groove
in the housing.
12. Install the wear plate and align the holes in the wear
plate with threaded holes in the housing.
NOTE: The holes in the wear plate are symmetrical.
13. Install the drive, making sure the slot in the drive
engages the pin.
14. Lubricate and install a new o–ring seal in the groove
in the wear plate.
15. Install the gerotor and align the screw holes.
16. Lubricate and install a new o–ring seal in the groove
in the gerotor ring.
17. Lubricate and install a new o–ring and seal ring in
the groove in the gerotor star.
18. Install the spacer.
19. Install the end cap and seven capscrews. Tighten
the capscrews, in a crossing pattern, to a torque to 16
– 18 Nm (140 – 160 in–lb).
20. Remove the steering control unit from the vise.
21. Install the relief/check valve and plug. Use a new
o–ring and tighten the plug to 17 Nm (150 in–lb).
Figure 138
To Next Page
Loading...
