Toro Reelmaster 6500–D - Verify Height of Cut; Grass Shield and Fin Adjustment

Reelmaster 6500–D/6700–D Page 7 – 11 Cutting UnitsRev. B
Model 03853
Model 03854
Model 03855
Verify Height of Cut
1. On gauge bar, set head of screw to desired Height–
of–Cut. This measurement is from bar face to underside
of screw head.
2. Place the bar across the front and rear rollers and ad-
just the rear roller up or down until the underside of
screw head engages the bedknife edge. Do this on both
ends of reel.
Figure 16
1. Gauge bar
1
Grass Shield and Fin Adjustment
Adjust grass shield and/or shield fin angle for desired
grass clippings dispersion.
1. Position cutting unit on a flat level surface.
2. To adjust fins, unhook and move front mounting tab
to the straight ahead or angled position slot. Set fins to
prevent windrowing of clippings. Windrowing can occur
due to the helix of the reel or when clippings are dis-
charged onto frame members or tires.
3. To change grass shield angle, loosen flange head
capscrew securing shield to left side plate, move shield
to desired angle and tighten screw.
Figure 17
1. Shield fin
2. Grass shield
1
2
Cutting Units
03853, 03854, 03856