Reelmaster 6500–D/6700–D Page 8 – 11 Cutting Units
Rev. B
Model 03857, S/N 80001–80301
Model 03858, S/N 80001–81418
Model 03859, S/N 80001–81992
Final Height of Cut Adjustment
1. Using a gauge bar, Toro part no. 98–1852 or equiva-
lent (Fig. 15), set head of screw to desired Height–of–
Cut. This measurement is from bar face to underside of
screw head.
2. Place gauge bar across front and rear rollers. Verify
at each end (Fig. 16). Adjust as required.
IMPORTANT: Set properly, front and rear rollers will
contact gauge bar and screw head will be snug over
bedknife cutting edge when checked at both ends of
the reel.
If an adjustment to attain the desired height–of–cut or at-
titude is required, either front or rear roller may be ad-
justed. Re–check leveling, with a piece of paper and
leveling plate, after adjustments are complete.
IMPORTANT: Each reel must be set consistently. Minor
differences in either height–of–cut or attitude between
cutting units may result in inconsistent quality of cut.
Figure 15
FINAL HOC SETTING
FRONT ROLLER
GAUGE BAR ASS’Y 98–1852
Figure 16
1. Gauge bar
1
Cutting Units
03857, 03858, 03859
To Next Page
Loading...
