Toro Reelmaster 6500–D - Cutting Unit Attitude Adjustment

Reelmaster 6500–D/6700–D Page 8 – 13 Cutting Units
Rev. B
Model 03857, S/N 80001–80301
Model 03858, S/N 80001–81418
Model 03859, S/N 80001–81992
Cutting Unit Attitude Adjustment (2 Screw Gauge Bar)
The cutting unit attitude may be adjusted or verified
using a gauge bar, Toro part no. 98–1852. which has
two screws and three hole locations. The second screw
is used in the inner hole to set or verify cutting attitude.
Adjust as follows:
1. Set front screw height to final height–of–cut setting
(Fig. 18).
2. Set rear screw, distance “B”, lower than front setting
(Fig. 18).
.20” (5.3mm) 8_
.15” (3.8mm) 6_
.09” (2.3mm) 4_
.04” (1.0mm) 2_
3. Place gauge bar across front and rear rollers. Front
screw head should fit snugly over edge of bedknife and
end of rear screw should contact bottom of bedknife
(Fig. 19 & 20). Front and rear rollers should contact
gauge bar. Verify attitude at each end.
Figure 18
ADJUST FOR FINAL HOC SETTING
“B”
Figure 19
BEDKNIFE
Figure 20
Cutting Units
03857, 03858, 03859