Page 1 - 2
Safety
Sand Pro 2040Z
Safety Instructions
The Sand Pro 2040Z is tested and certified by Toro for
compliance with existing safety standards and speci-
fications. Although hazard control and accident preven-
tion partially are dependent upon the design and
configuration of the machine, these factors are also de-
pendent upon the awareness, concern and proper train-
ing of the personnel involved in the operation, transport,
maintenance and storage of the machine. Improper use
or maintenance of the machine can result in injury or
death. To reduce the potential for injury or death, comply
with the following safety instructions.
WARNING
To reduce the potential for injury or death, com-
ply with the following safety instructions.
Before Operating
1. Review and understand the contents of the Opera-
tor’s Manual and Operator’s DVD before starting and
operating the vehicle. Become familiar with the controls
and know how to stop the vehicle and engine quickly.
Additional copies of the Operator’s Manual are available
on the internet at www.Toro.com.
2. Keep all shields, safety devices and decals in place.
If a shield, safety device or decal is defective, illegible
or damaged, repair or replace it before operating the
machine.
3. Before machine operation, tighten any loose nuts,
bolts or screws to ensure machine is in safe operating
condition.
4. Wearing safety glasses, safety shoes, long pants
and a helmet is advisable and required by some local
safety and insurance regulations.
5. Ensure that the traction interlock switch is adjusted
correctly so the engine cannot be started unless the
control handles are placed in the neutral locked position.
6. When attachments are installed to your Sand Pro,
additional weight may be required to comply to safety
standards. Refer to your Operator’s Manual for addi-
tional information.
7. Never operate your Sand Pro without the rear at-
tachment installed.
8. Since gasoline is highly flammable, handle it careful-
ly:
A. Store fuel in containers specifically designed for
this purpose.
B. Do not remove machine fuel tank cap while en-
gine is hot or running.
C. Do not smoke while handling fuel.
D. Fill fuel tank outdoors and only to within an inch of
the top of the tank, not the filler neck. Do not overfill
the fuel tank.
E. If fuel is spilled, do not start engine. Move the ma-
chine away from the area of spillage and allow the
gasoline vapors to dissipate. Properly dispose of any
spilled fuel.
To Next Page
Loading...
