Page 1 - 4
Safety
Sand Pro 2040Z
Jacking Instructions
CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks, hoists and
supports. Make sure machine is parked on a sol-
id, level surface such as a concrete floor. Prior
to raising machine, remove any attachments
that may interfere with the safe and proper rais-
ing of the machine. Always chock or block
wheels. Use jack stands to support the raised
machine. If the machine is not properly sup-
ported by jack stands, the machine may move or
fall, which may result in personal injury.
Use the following procedure when jacking up the ma-
chine:
1. To prevent the machine from shifting, place suitable
chocks or blocks under tires that will remain on the
ground.
2. Jack the front or rear of the machine at the support
points of the frame as shown in Fig. 1. Make sure that
jack is positioned securely under frame to reduce the
chance that the machine could shift while being raised.
3. Use appropriate jackstands at frame support points
to keep raised machine from moving.
Figure 1
1. Front support points 2. Rear support points
1
2
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
your Sand Pro. If any decal becomes illegible or dam-
aged, install a new decal. Part numbers for replacement
decals are listed in your Parts Catalog. Order replace-
ment decals from your Authorized Toro Distributor.
To Next Page
Loading...
