Page 5 - 6
Electrical System
Sand Pro 2040Z
Starting Problems (Continued)
Problem Possible Causes
Starter solenoid clicks, but starter will not crank
(if starter solenoid clicks, problem is not in safety
interlock system).
Battery is discharged or faulty.
Battery cables are loose or corroded.
Ground connection to frame is loose or corroded.
Cable connection at starter is faulty.
Starter solenoid is faulty.
Starter motor mounting bolts are loose or not supplying
a sufficient ground for starter operation.
Engine starter motor is faulty.
Engine cranks, but does not start. Fuel tank is empty.
Engine may be too cold.
Wiring to interlock components is loose, corroded or
damaged (see electrical schematic and wire harness
drawings in Chapter 7 - Electrical Drawings).
Ignition switch or circuit wiring is faulty.
Engine fuel solenoid or circuit wiring is faulty.
Spark plugs are faulty.
Engine or fuel system is malfunctioning (see Chapter 3
- Gasoline Engine and/or Kawasaki FX481V Service
Manual).
Engine cranks slowly. Battery is discharged or faulty.
Engine is too cold.
Battery cables are loose or corroded.
Engine is malfunctioning (see Kawasaki FX481V
Service Manual).
To Next Page
Loading...
