Page 5 - 10
Electrical System
Sand Pro 2040Z
Component Testing
For accurate resistance and/or continuity checks, elec-
trically disconnect the component being tested from the
circuit (e.g. unplug the ignition switch wire harness con-
nector before checking continuity between switch termi-
nals).
Ignition Switch
The ignition (key) switch has three positions (OFF, RUN,
and START) (Fig. 6). The switch terminals are identified
asshowninFigure7.
Testing
The circuitry of the ignition switch is shown in the chart
below. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various terminals for each
switch position.
Unplug wire harness connector from switch and verify
continuity between switch terminals. Reconnect the har-
ness connector to the switch after testing.
POSITION
CIRCUIT
OFF G+M+A
RUN B+L+A
START B+L+S
Figure 6
45
45
RUN
START
OFF
o
o
G
L
B
S
M
A
Figure 7
To Next Page
Loading...
