Page 5 - 11 Electrical SystemSand Pro 2040Z
Fuses
The fuse block is located on the inside of the console
next to the operator seat (Fig. 8).
Fuse Identification and Function
Use the fuse block illustration shown in Figure 8 to iden-
tify each individual fuse and its correct amperage. The
fuses have the following functions and are listed from
rear fuse to front fuse.
Fuse 1 (20 amp) protects ignition switch power supply
circuits.
Fuse 2 (25 amp) protects engine alternator circuit.
Fuse 3 (10 amp) protects power supply for the rear at-
tachment lift circuit.
Fuse 4 (15 amp) protects optional light circuit (if
equipped).
Fuse Testing
Turn ignition switch to the ON position (do not start en-
gine).Withthefuseinstalledinthefuseblock,usea
multimeter to verify that 12 VDC exists at both of the ter-
minal test points on the fuse. If 12 VDC exists at one of
the fuse test points but not at the other, the fuse is faulty.
If necessary, make sure that ignition switch is OFF and
key is r emoved from switch. Remove fuse from fuse
block and check that fuse has continuity across the fuse
terminals.
1. Fuse1(20amp)
2. Fuse2(25amp)
3. Fuse3(10amp)
4. Fuse 4 (15 amp)
5. Console
Figure 8
2
3
1
4
5
Electrical
System
To Next Page
Loading...
