Toro Sand Pro 3040 - Rear Lift Cylinder

RearLiftCylinder
g351871
Figure62
(viewfromundermachine)
1.Capscrew
4.Rearhitch
2.Pin
5.Capscrew
3.Liftcylinder
6.Flatwasher
RemovingtheRearLiftCylinder
RefertoFigure62forthisprocedure.Therearliftcylinderislocatedonthe
leftsideofthemachine.
1.Parkthemachineonalevelsurface,loweranyattachments,setthekey
switchtotheOFFpositionandremovethekeyfromtheswitch.
2.ReadandadheretotheinformationprovidedinGeneralPrecautionsfor
RemovingandInstallingtheHydraulicSystemComponents(page5–54).
3.Cleanthettingandhydraulichoseconnectionsbeforedisconnectingthe
hydraulichosestopreventsystemcontamination.
4.Disconnectthehydraulichoses.Capthettingsandplugthehosesto
preventsystemcontamination.
5.Removethefastenerfromthepinthatsecuresthecylinderclevistotherear
hitchandslidethepinfromthehitchandtheliftcylinder.
6.Removethefastenersthatsecuretheliftcylindertotheframeandremove
theliftcylinderfromthemachine.
7.Ifthehydraulicttingsaretoberemovedfromthecylinder,markthetting
orientationforassemblypurposesandremovethettingsfromthecylinder.
DiscardtheO-ringsfromthettings.
HydraulicSystem:ServiceandRepairs
Page5–94
SandPro
®
3040and5040
20251SLRevA