Toro Sand Pro 3040 - Hydraulic Switch Kit Manifold (Optional)

HydraulicSwitchKitManifold(Optional)
g352652
Figure74
1.Flatplain(3each)5.Capscrew(2each)
9.Hydraulictankclamp
2.Capscrew6.Clamp
10.Locknut
3.Capscrew(2each)7.Hydraulicmanifoldassembly
4.Couplerpanel8.Manifoldbracket
RemovingtheHydraulicSwitchKitManifold
RefertoFigure74forthisprocedure.
1.Removethehydraulictank;refertoRemovingtheHydraulicTank(page
5–66).
2.Cleanthehydraulichoseends,andttingsonthemanifoldtoprevent
contaminantsfromenteringintothehydraulicsystem.
3.Labelandremovethehydraulichosesfromthettingsonthemanifold.Allow
thetubesandhosestodrainintoasuitablecontainer.
4.Installcleancapsandplugsonthehydraulichoses,andttingstoprevent
systemcontamination.
5.Labelanddisconnectthewireharnessconnectorsfromthesolenoidvalves.
6.Removethefastenerssecuringthemanifoldbrackettothemachine.
Note:Themanifoldbracketshouldbelooseoncethehydraulictankclamps
havebeenremoved.
7.Supportthemanifoldassembly,removethefastenerssecuringthecoupler
panelandthemanifoldassemblytothehitchtubeandremovethemanifold
assemblyfromthemachine.
8.Dismantlethemanifoldassemblyifnecessary;refertoServicingtheOptional
HydraulicSwitchKitManifold(page5–119).
9.Ifthehydraulicttingsaretoberemovedfromthemanifold,markthetting
orientationforassemblypurposesandremovethettingsfromthemanifold.
DiscardtheO-ringsfromthettings.
SandPro
®
3040and5040
Page5–117
HydraulicSystem:ServiceandRepairs
20251SLRevA