Toro Sand Pro 3040 - Mounting the Drag Mat Carrier to the Traction Unit

2.Ifyouareinstallingthecoconut-bermat,drillahole
(3/8inch)inthematateachclamplocation,usingthe
matretainerasatemplate(Figure7).
Figure7
1.Drag-matcarrier
5.Aligntheedgeofthemat
totherearedgeofthe
carrier.
2.Bolt—3/8x1inch(11)6.Coconut-bermat
3.Matretainer(11)7.Flangenut—3/8inch(11)
4.Drillahole(3/8inch)here.
3.Foreithermat,securetheedgeofthemattothedrag
matcarrierasshowninFigure7,using5bolts(3/8x1
inch),matretainers,andangenuts(3/8inch).
4.Wrapthematunderthedragmatcarrierandrepeat
steps1through3forthefrontedgeofthecarrierusing
theremainingmountinghardware.
5.Ifyouwillbeusingthedragmatcarrieronagolfgreen,
removetheskidlocatedoneachsideofthecarrier
frame(Figure8).
Note:Usingthesteelmatisnotrecommendedon
golfgreens.
Figure8
1.Drag-matcarrierside3.Bolt
2.Skid
4.Nut
3
MountingtheDragMatCarrier
totheTractionUnit
NoPartsRequired
Procedure
1.Removeanyattachmentfromtherearofthemachine.
2.Lowerthetraction-unitadapter.Backthetractionunit
intopositioninfrontoftheattachmentadapter.
Note:Makesurethatthelockingleverispivotedto
theleft(unlockedposition)asviewedfromtherear
ofthemachine.
3.Slidetheattachmentadapterontotheadapteronthe
tractionunit.
Note:Positionthelonglegofthelift-armassembly
undertherearframeofthetractionunit(Figure9).
6