Blade Service (continued)
G451422
Blade (in position for measuring)
Level surface
Measured distance between blade
and the surface (A)
4. Rotate the same blade 180 degrees so that the opposite blade edge is now in the same
position.
G451423
Blade edge previous measured
Opposite blade edge
5. Measure from the tip of the blade to the level surface.
G451422
Blade (in position for measuring)
Level surface
Measured distance between blade
and the surface (B)
6. If the difference between A and B is greater than 3 mm (1/8 inch), replace the blade.
Note: If you replace the blade and the difference continues to exceed 3 mm (1/8 inch),
the blade spindle could be bent. Contact an Authorized Service Dealer for service.
7. Repeat this procedure each blade.
3464-628A Page 5–24 Maintenance: Mower-Deck Maintenance
To Next Page
Loading...
