Checking the Wheel Lug Nuts
Check and torque the wheel lug nuts to 108 N∙m (80 ft-lb).
Adjusting the Tracking
When driving the machine forward full speed across a flat, level surface, if the machine pulls
to 1 side, adjust the tracking.
If the machine pulls to the left, adjust the right motion-control lever; if the machine pulls to
the right, adjust the left motion-control lever.
Note: You can adjust the tracking only for driving forward.
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
ARK position.
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Locate the tracking-adjustment bolt near the motion-control lever on the particular side
that needs adjusting.
G453528
4. Rotate the bolt to decrease the speed for that particular wheel.
Note: Rotate the bolt a small amount to make minor adjustments.
5. Start the machine and drive forward across a flat, level surface with the motion-control
levers fully forward to check if the machine tracks straight. Repeat the procedure as
needed.
Maintenance: Drive System Maintenance Page 5–20 3464-634 A
To Next Page
Loading...
