HYDROSTATIC DRIVE SYSTEM
7-16 2007 - 2008 Titan Z Service Manual
7
Brake Linkage & Brake Handle
Assembly Replacement
Brake Linkage & Brake Handle Assembly
Removal
1. Raise the seat.
2. Remove the negative and then the positive battery
cable from the battery.
3. Loosen the two wing nuts on the battery hold down
bolts and remove the battery from the machine (Fig.
410).
Fig. 410 IMG-0456
10. Install the positive and then the negative battery
cable to the battery.
11. Start the machine and allow it warm up. Check
the forward, reverse and neutral operation. If the
machine needs neutral adjustment, refer to “Neutral
Adjustment” on page 7-39.
9. Position the battery into the machine. Install the
battery hold down bracket to secure (Fig. 409).
Fig. 409 IMG-0456
To Next Page
Loading...
