HYDROSTATIC DRIVE SYSTEM
7-232007 - 2008 Titan Z Service Manual
7
5. Install the right side spring anchor plate onto the
right brake handle clevis pin. Install a cotter pin to
secure (Fig. 434).
7. Install an e-clip to retain the brake arm to the brake
shaft assembly (Fig. 436).
Fig. 434 IMG-0539a
6. Install the brake arm from the brake shaft assembly
to the seat box assembly (Fig. 435).
Fig. 435 IMG-0529
Fig. 436 IMG-0528a
8. Rotate the brake shaft assembly up and slide the
right and left spring anchor plates through the slots
in the brake shaft assembly (Fig. 437).
Fig. 437 IMG-0543
To Next Page
Loading...
