Toro Titan Z5200 - Hydraulic System Maintenance; Checking Hydraulic Oil Level

CHASSIS
3-18 2007 - 2008 Titan Z Service Manual
3
3. Install three screws to secure the right hand fender
to the top of the seat box assembly (Fig. 062).
4. Plug the wire harness plug onto the terminals on the
hour meter (Fig. 063).
6. Connect the two red wire terminal to the outside
terminal on the ignition switch (Fig. 065).
5. Plug the wire harness plug onto the PTO switch (Fig.
064).
Fig. 062 IMG-0209
Fig. 063 IMG-0213
Fig. 064 IMG-0212
Fig. 065 IMG-0218