Toro Titan Z5200 - Mower Blade Maintenance; Checking Blades for Bends; Checking Blades and Washers; Removing Mower Blades

CHASSIS
3-252007 - 2008 Titan Z Service Manual
3
21. Remove the wire harness plug from the right side
neutral switch (Fig. 088).
23. Remove the wires from the four solenoid terminals
(Fig. 090).
20. Locate the clamp that the throttle and choke cables
are routed through on the right side of the seat box.
Remove the clamp from the seat box (Fig. 087).
22. Remove the wire harness plug from the left side
neutral switch (Fig. 089).
Fig. 087 IMG-0240
Fig. 088 IMG-0245
Fig. 089 IMG-0247
Fig. 090 IMG-0251
A. Kill Relay/PTO Clutch (Green/Green)
B. Ignition Switch (Blue)
C. Starter (Red)
D. Battery and Fuse block (Large red and small red)
A
C
B
D