CHASSIS
3-412007 - 2008 Titan Z Service Manual
3
33. Route the PTO clutch wire through the hole in the
frame in front of the engine (Fig. 153).
30. Install the relay into the harness plug (Fig. 150). 32. Pull the wire harness from inside the rear of the seat
box assembly toward the outside through the thru
hole. Install the rubber grommet into the thru hole to
protect the wire harness (Fig. 152).
Fig. 150 IMG-0331
Fig. 152 IMG-0332a
Fig. 153 IMG-0338
31. Install two wire harness clamps that secure the
wiring harness to the inside, rear of the seat box
(Fig. 151).
Fig. 151 IMG-0283a
To Next Page
Loading...
