CHASSIS
3-432007 - 2008 Titan Z Service Manual
3
39. Install the two ground wires to the engine base and
install a nut to secure (Fig. 159).
38. Install the yellow/white wire plug into the grey/black
wire plug that goes to the fuel solenoid and engine
magneto (Fig. 158).
40. Position the solenoid to the back side of the seat
box assembly. Install two bolts, washers, and nuts to
secure it to the seat box assembly (Fig. 160).
Fig. 158 IMG-0258
Fig. 159 IMG-0257
Fig. 160 IMG-0254a
41. Install the wires on the four solenoid terminals (Fig.
161):
Fig. 161 IMG-0251
A. Kill Relay/PTO Clutch (Green/Green)
B. Ignition Switch (Blue)
C. Battery and Fuse block (Large red and small red)
D. Starter (Red)
A
B
C
D
To Next Page
Loading...
