ELECTRICAL
7-3
Toro TITAN 2009-2013 Service Manual
7
Continuity Testing
Terminals viewed from the back of the switch.
With the Switch “ON” (Button pulled OUT):
- Pin 2 and 5 should have continuity (closed - circled below)
- Pin 1 and 4 should have continuity (closed - circled below)
- Pin 1 and 7 should not have continuity (open)
- Pin 2 and 8 should not have continutiy (open)
(Fig. 135 and Fig. 136)
Fig. 135 PICT-1005
Fig. 136 PICT-2004
3 9
2
5
8
1
4
7
With the Switch “OFF” (Button pushed IN):
- Pin 1 and 7 should have continuity (closed - circled below)
- Pin 2 and 8 should have continuity (closed - circled below)
- Pin 2 and 5 should not have continuity (open)
- Pin 1 and 4 should not have continuity (open)
(Fig. 137 and Fig. 138)
Fig. 138 PICT-2003
Fig. 137 PICT-1006
3 9
2
5
8
1
4
7
Note: Switch pins 3 and 9 are not used.
To Next Page
Loading...
