CHASSIS
3-10
Toro TITAN 2009-2013 Service Manual
3
Seat Style 2 – Remove the (4) bolts and washers (C)
that attach the seat base to the rubber mounts (D)
(Fig. 019).
Fig. 019 PICT-2074
5. Remove the RH and LH fenders as shown in this
chapter.
6. Safely remove the fuel tank as shown in this chapter.
Fig. 018 PICT-2073
Motion Control Box / Seat Pivot
Service
Note: The entire Control Box / Motion Control
assembly does not need to be removed to
service the Actuator Arm assembly. The
Control Box is shown removed from the frame
for clarity and ease of service.
Motion Control Box / Seat Pivot Removal
1. Raise seat, disconnect battery terminals and remove
the battery from the unit.
2. Remove the (2) control handles.
3. Disconnect the seat switch harness connection and
remove seat switch harness from the routing clip on
the Motion Control Box.
4. Remove the operator’s seat:
Seat Style 1 - Remove the (2) retaining clips (A), seat
pivot rod (B), and seat from the unit (Fig. 018).
A
B
C
D
To Next Page
Loading...
