MOWER DECK
6-23
Toro TITAN 2009-2013 Service Manual
6
Leveling the Mower Deck
1. Set anti-scalp rollers to top holes or remove
completely for this procedure.
2. Set the height-of-cut lever to the 3 inch (76mm)
position.
3. Place two 2-5/8 inch (6.66cm) blocks under each
side of the front edge of the deck, but not under
the anti-scalp roller brackets. Place two 2-7/8 inch
(7.30cm) thick blocks under the rear edge of the
cutting deck skirt; one on each side of the cutting
deck (Fig. 124).
tighten the four leveling adjust locking nuts (C) (Fig.
125 and Fig. 126).
A. Wood block, 2-5/8” (6.66cm) thick
B. Wood block, 2-7/8” (7.30cm) thick
C. Front edge
Fig. 124 g. 64 G010336
Fig. 125 g. 65 G010342
48 and 54 inch mower decks
A. Deck lift arm D. Slot in deck hanger
B. Deck hanger E. Slot in rear deck hanger
C. Leveling adjust bracket
locking nut F. Rear deck hanger bracket
60 inch mower decks
A. Deck lift arm C. Leveling adjust locking nut
B. Deck hanger D. Slot in deck hanger
Fig. 126 g. 66 G010321
A
B
C
A
B
D
E
F
C
C
A
4. Loosen the leveling adjust locking nuts (C) on all
four corners so that the deck is sitting securely on
all four blocks. Make sure that the deck hangers are
all the way down (at the top of the slot) and the deck
lift foot lever is pushed back against the stop, then
A
B
C
D
D
A BC
To Next Page
Loading...
