Toro TurfMaster 22205TE - Engine Oil and Cutting Height Checks; Checking Engine-Oil Level; Adjusting Cutting Height

SUPERCEDED
CheckingtheEngine-OilLevel
ServiceInterval:Beforeeachuseordaily
1.Movethemachinetoalevelsurface.
2.Removethedipstickbyrotatingthecap
counterclockwiseandpullingitout(Figure14).
g194742
Figure14
1.Full3.Low
2.High
3.Wipethedipstickcleanwithacleancloth.
4.Insertthedipstickintotheoil-lltube,thenremove
thedipstick.
5.Readtheoillevelonthedipstick(Figure14).
•IftheoilisbelowtheAddmarkonthedipstick,
carefullypourasmallamountofoilintotheoil-ll
tube,wait3minutes,andthenrepeatsteps3
through5untiltheoillevelisattheFullmarkon
thedipstick.
•IftheoilisabovetheFullmarkonthedipstick,
draintheexcessoiluntiltheoillevelisattheFull
markonthedipstick.Todraintheexcessoil,refer
toChangingtheEngineOil(page18).
Important:Iftheoillevelinthecrankcaseistoo
lowortoohighandyouruntheengine,youmay
damagetheengine.
6.Installthedipstickintotheoil-lltubesecurely.
AdjustingtheCuttingHeight
Thecuttingheightsrangefrom38mm(1-1/2inches)to127
mm(5inches)in13mm(1/2inch)increments.
1
2
4
6
7
8
3
5
G01991 1
g019911
Figure15
Viewfromfront,leftsideofthemachine
1.38mm(1-1/2inches)5.89mm(3-1/2inches)
2.51mm(2inches)6.102mm(4inches)
3.64mm(2-1/2inches)7.114mm(4-1/2inches)
4.76mm(3inches)8.127mm(5inches)
Thecuttingheightiscontrolledwithafrontleverandarear
lever,bothontheleftsideofthemachine(Figure16and
Figure17).Toraiseorlowerthemachine,engagethelever,
raiseorlowerthemachine,andthendisengagethelever.
g019653
1
g019653
Figure16
Frontcutting-heightlever
1.Squeezethelevertodisengageit.
10