116
HDX152A
8. Install the CVT cooling ducts on the V-bolt hous-
ing and secure with clamps. Tighten securely.
Install an appropriate nylon tie to secure the
exhaust duct.
HDX135A
9. Install the starter cable to the starter motor, secure
with the nut, and tighten securely; then secure the
engine/harness ground wires to the engine with a cap
screw and tighten to 8 ft-lb.
HDX149A
10. Properly position the gear position switch on the
engine (A to A and B to B); then secure the shift
cable bracket to the engine case and tighten the
engine case screws to 8 ft-lb. Connect the gear posi-
tion switch connector.
HDX252A
HDX253A
11. On the left side, connect the ECT sensor connec-
tor, speed sensor connector, and spark plug cap.
HDX135A
HDX137A
12. Install the throttle body into the intake manifold boot
and secure with the clamp. Tighten to 30 in.-lb.
700
500
To Next Page
Loading...
