Toro UTV700AAC00000 - Troubleshooting Drive System

169
PR368
2. Secure a U-joint separator tool in a vise; then place
the yoke, joint, and bearing cup into position and
press the cup into the yoke.
PR374
3. Install the retainer in the bearing cup; then remove
the yoke from the separator tool.
NOTE: Repeat steps 2-3 for the opposite-side bear-
ing cup.
4. Remove the separator tool from the vise and install
the universal joint, bearing cups, and movable yoke
into the fixed yoke using the same procedure as steps
2-3 except the vise cannot be used.
PR355
5. Check that the universal joint can be flexed freely
without binding; then apply multi-purpose grease to
the splines and install the driveshaft noting the match
marks made prior to removing.
Troubleshooting Drive
System
Problem: Power not transmitted from engine to wheels
Condition Remedy
1. Rear axle shaft serration worn - broken 1. Replace shaft
Problem: Power not transmitted from engine to either front wheel
Condition Remedy
1. Secondary drive - driven gear teeth broken
2. Propeller shaft serration worn - broken
3. Coupling damaged
4. Coupling joint serration worn - damaged
5. Front drive - driven bevel gears broken - damaged
6. Front differential gears/pinions broken - damaged
7. Front drive actuator not operating
1. Replace gear(s)
2. Replace shaft
3. Replace coupling
4. Replace joint
5. Replace gear(s)
6. Replace gears - pinions
7. Replace fuse - drive select switch - front drive actuator