17
1. Choose an area large enough to safely accelerate the
vehicle to 30 mph and to brake to a stop.
2. Accelerate to 30 mph; then depress the brake pedal
to decelerate to 0-5 mph.
3. Repeat procedure 20 times until brake pads are bur-
nished.
Checking/Replacing V-
Belt
REMOVING
1. Remove the seat, seat back, and seat base; then
remove the floor and gas tank.
2. Remove the cap screws securing the CVT cover not-
ing the location of the different-lengthed cap screws
for installing purposes; then using a rubber mallet,
gently tap on the cover tabs to loosen the cover.
Remove the cover.
CF363
3. Remove the nut securing the movable drive face;
then remove the face. Account for the spacer.
NOTE: Keep the drive face plate in contact with the
drive face when removing or installing the drive face
to prevent the rollers from falling out.
CF364A
CD966A
4. Install one of the CVT cover cap screws into the
driven pulley fixed face; then turn the cap screw
clockwise to spread the pulley faces. Remove the V-
belt.
GZ076
GZ085
INSTALLING
1. Place the V-belt into position on the driven pulley
and over the front shaft.
To Next Page
Loading...
