24
PR203
3. Install the tie rod end and secure with the nut (coated
with red Loctite #271). Tighten to 30 ft-lb; then
install a new cotter pin and spread the pin.
NOTE: During assembling, new cotter pins should
be installed.
4. Apply a small amount of grease to the hub splines.
PR290A
5. Install the hub assembly onto the splines of the shaft.
CD009
6. Secure the hub assembly with the nut. Tighten to 200
ft-lb.
PR256
7. Install a new cotter pin and secure by spreading as
shown.
PR260
NOTE: If the hole in the axle shaft does not align
with the slots in the castle nut, tighten the nut until
the hole and slots align.
8. Secure the brake caliper to the knuckle with the two
new “patch-lock” cap screws. Tighten to 20 ft-lb.
PR377B
9. Install the wheel; then using a crisscross pattern,
tighten the wheel nuts in 27 N-m (20 ft-lb) incre-
ments to the final torque shown in the table below.
10. Remove the vehicle from the support stand.
Steel Wheel 54 N-m (40 ft-lb)
Aluminum Wheel (Black Nuts) 80 N-m (60 ft-lb)
Aluminum Wheel (Chrome Nuts) 108 N-m (80 ft-lb)
To Next Page
Loading...
