26
2. Remove the nut securing the shift cable to the shift
arm stud; then loosen the upper adjuster nut on the
shift cable and remove the shift cable from the shifter
assembly.
HDX166A
HDX178A
3. Tilt the cargo box back and remove the E-clip from
the shift arm on the transmission; then loosen the
adjuster nut on the shift cable housing and remove
the shift cable from the transmission.
HDX137B
4. Remove the center floorboard and remove all nylon
ties securing the cable housing to the frame; then
remove the shift cable.
NOTE: If the cable is being replaced, connect the
new cable to the end of the cable being removed and
pull the new cable into place.
HDX132A
INSTALLING
1. Route the cable into position making sure there are
no kinks or sharp bends.
2. Install the cable housing onto the transmission
holder; then connect the cable end to the shift arm
and secure with the E-clip.
3. Install the shift cable into the shift cable support;
then connect the shift cable end to the shifter and
secure with a cap screw and nut. Tighten to 8 ft-lb.
4. Adjust the shift cable (see Periodic Maintenance -
Shift Lever).
5. Install nylon ties on the shift cable where removed;
then install the center floorboard and tighten the
machine screws securely.
6. Install the dashboard (see Dashboard in this section).
7. Shift the transmission through all positions making
sure the gear position icons indicate the appropriate
gears selected and that the Park Indicator illuminates
only when fully in Park (see Periodic Maintenance -
Shift Lever).
LCD Gauge
REPLACING
1. Remove the steering wheel; then remove the steering
wheel boot.
2. Remove the two machine screws securing the steer-
ing wheel boot support to the steering support assem-
bly. Remove the boot support.
To Next Page
Loading...
