Toro UTV700AAC00000 - Troubleshooting

33
Troubleshooting
Problem: Handling too heavy or stiff
Condition Remedy
1. Front wheel alignment incorrect
2. Steering shaft binding
3. Tire inflation pressure incorrect
4. Tie rod ends seizing
5. U-joints seized
1. Adjust alignment
2. Lubricate/replace steering shaft
3. Adjust pressure
4. Replace tie rod ends
5. Replace U-joints
Problem: Steering oscillation
Condition Remedy
1. Tires inflated unequally
2. Wheel(s) bent
3. Wheel hub studs loose - missing
4. Wheel hub bearing worn - damaged
5. Tie rod ends worn - loose
6. Tires defective - incorrect
7. A-arm bushings damaged
8. Bolts - nuts (frame) loose
1. Adjust pressure
2. Replace wheel(s)
3. Tighten - replace wheel studs
4. Replace bearing
5. Replace - tighten tie rod ends
6. Replace tires
7. Replace bushings
8. Tighten bolts - nuts
Problem: Steering pulling to one side
Condition Remedy
1. Tires inflated unequally
2. Front wheel alignment incorrect
3. Wheel hub bearings worn - broken
4. Frame distorted
5. Shock absorber defective
1. Adjust pressure
2. Adjust alignment
3. Replace bearings
4. Repair - replace frame
5. Replace shock absorber
Problem: Steering impaired
Condition Remedy
1. Tire pressure too high
2. Steering linkage worn
3. Cap screws (suspension system) loose
1. Adjust pressure
2. Replace linkage
3. Tighten cap screws
Problem: Tire wear rapid or uneven
Condition Remedy
1. Wheel hub bearings worn - loose
2. Front wheel alignment incorrect
1. Replace bearings
2. Adjust alignment
Problem: Steering noise
Condition Remedy
1. Caps screws - nuts loose
2. Wheel hub bearings broken - damaged
3. Lubrication inadequate
1. Tighten cap screws - nuts
2. Replace bearings
3. Lubricate appropriate components
Problem: Rear wheel oscillation
Condition Remedy
1. Rear wheel hub bearings worn - loose
2. Tires defective - incorrect
3. Wheel rim distorted
4. Wheel hub cap screws loose
5. Rear suspension arm-related bushing worn
6. Rear shock absorber damaged
7. Rear suspension arm nut loose
1. Replace bearings
2. Replace tires
3. Replace rim
4. Tighten cap screws
5. Replace bushing
6. Replace shock absorber
7. Tighten nut