Toro UTV700AAC00000 - Page 62

60
KC142A
3. Mark the movable drive face and the fixed drive face
for installing purposes; then remove the nut holding
the movable drive face onto the crankshaft.
MD1033
4. Remove the movable drive face and spacer. Account
for the movable drive face rollers and outer drive
face cover.
MD1035
MD1034
MD1036
5. Using a 6 mm cap screw threaded into the fixed
driven face, spread the driven pulley by turning the
cap screw clockwise; then remove the V-belt.
KC132
6. Remove the fixed drive face.
MD1094
7. Remove the nut holding the driven pulley assembly;
then remove the driven pulley assembly.
MD1068