Toro UTV700AAC00000 - Page 74

72
FI665
3. Remove the low driven gear washer; then remove the
low driven gear along with the bearing and bushing.
FI666
FI667
4. Remove the splined washer; then remove the circlip
securing the high-low sliding dog. Remove the slid-
ing dog.
FI668
FI669
5. Remove the circlip securing the high driven gear;
then remove a washer, the high driven gear along
with the bearing and bushing, and remove the high
driven washer.
FI670
FI671
ASSEMBLING
1. With the high driven washer (1) on the countershaft,
install the high driven gear bushing (3), bearings (2),
and gear (4) on the countershaft; then install the
washers (5) and secure with the snap-ring.