92
7. Using an appropriate side case puller, remove the
side cover. Account for a gasket and two alignment
pins.
8. Remove the nut securing the magneto rotor to the
crankshaft; then install the magneto rotor puller
adapter.
NOTE: The puller has left-hand threads.
9. Using Magneto Rotor Remover Set and the appropri-
ate crankshaft protector, remove the rotor/flywheel
assembly from the crankshaft. Account for the key;
then remove the starter clutch gear assembly and
washer.
PR441
CD939A
CD940A
10. Remove the two starter gears from the crankcase not-
ing the direction of the beveled side of the gears for
installing purposes; then remove the two starter gear
shafts.
CD136
CD140
11. Remov e the snap ring securing the water pump driv e
gear; then remove the gear noting the direction of the
sides of the gear for installing purposes. Account for the
dri v e gear alignment pin.
CD944
12. Remov e the snap ring securing the water pump dri v en
gear; then remove the gear noting the direction of the
sides of the gear for installing purposes. Account for the
dri v en gear alignment pin.
CD952A
To Next Page
Loading...
