Toro UTV700AAC00000 - Installing Left-Side Components

95
FI595A
Installing Left-Side
Components
NOTE: Plug the oil passage in the crankcase hous-
ing prior to installing the drive gear/driven gear
assembly to prevent loss of an alignment pin.
1. Install the water pump driven gear alignment pin and
the driven gear (with the beveled side of the gear fac-
ing outward as noted in removing); then secure with
the snap ring.
CD950A
CD952A
CD949
NOTE: The sharp side of the snap ring should be
facing outward.
2. Install the water pump drive gear drive pin and the
drive gear (with the flat side of the gear facing out-
ward as noted in removing); then secure with the
snap ring.
CD946A
CD944
NOTE: The sharp side of the snap ring should be
facing outward.
NOTE: Once the gears are secured, remove the oil
passage plug from the crankcase.
3. Install the two starter gear shafts; then install the two
starter gears (with the beveled side of the intermedi-
ate gear facing inward as noted in removing).