Workman HD Series Page 6 − 39 Drive Train
Transaxle Assembly
1. Clean gasket material from all mating surfaces be-
fore reassembling. Make sure all parts are clean and
free of dirt and dust.
IMPORTANT: Be careful not to damage mating sur-
faces when removing gasket material.
2. Assemble L.H. axle shaft:
A. Install new oil seal into differential carrier.
B. Use a press to install bearing onto L.H. axle shaft.
C. Install washer and snap ring.
D. Install L.H. axle shaft assembly into differential
carrier.
E. Install snap ring.
F. Install new O−ring. Apply multi−purpose grease
on O−ring before installing.
3. Assemble R.H. axle shaft:
A. Install new oil seal into seal cover. Apply multi−
purpose grease on O−ring before installing.
B. Insert washer.
C. Use a press to install bearing onto R.H. axle shaft.
D. Install washer and snap ring.
E. Install R.H. axle shaft assembly into seal cover.
L.H. SHAFT
R.H. SHAFT
1. O−ring
2. Snap ring
3. L.H. axle shaft assembly
4. Snap ring
5. Washer
6. Bearing
7. Oil seal
8. Differential carrier
9. R.H. axle shaft assembl
10. Snap ring
11. Washer
12. Bearing
13. Oil seal
14. Washer
15. Seal cover
Figure 65
5
6
7
4218 3
11 14 9
10 12
15 13
4. Assemble differential fork shaft:
A. Drive lock pins into fork shaft. Make sure lock pins
are installed with slit facing the correct direction.
B. Install fork, spring, washer and snap ring onto
fork shaft using a press. Apply moly disulfide grease
onto fork portion of fork shaft before installing.
C. Install new O−ring. Apply multi−purpose grease
on O−ring before installing.
1. O−ring
2. Snap ring
3. Washer
4. Spring
5. Fork
6. Lock pin
7. Fork shaft
Figure 66
6
543217
ARM
LOCK PIN
To Next Page
Loading...
